Enabling and configuring ACL Raslogs

For details of Raslog messages, refer to the Extreme SLX-OS Message Reference.

1. Enter the configure terminal command to access global configuration mode.
   

   device# configure terminal

2. Enter the acl-policy command to access ACL policy configuration mode.
   

   device(config)# acl-policy
   

3. Enter the acl-log-raslog command to enable ACL Raslogs.
   

   device(config-acl-policy)# acl-log-raslog
   

4. To modify the interval between the first ACL Raslog and each consecutive Raslog, enter the acl-log-raslog log-interval command.
   

   device(config-acl-policy)# acl-log-raslog log-interval 8
   

Example

The following output is an ACL Raslog example.

MAC ACL mac_2 permitted 1 packets on intf eth1/6 [SA:0010.1010.1001, DA:0001.0300.0500, 
Type:0, VLAN:101, SIP:0.0.0.0, DIP:0.0.0.0, l3_proto:none, src_port:0, dst_port:0]

IP ACL v4acl denied 1 packets on intf eth1/6  [SA:0001.0300.0400,DA:0001.0300.0500, 
Type:800, VLAN:100, SIP:2.2.2.2, DIP:6.6.6.6, l3_proto:udp, src_port:66, dst_port:77]

IPv6 ACL v6acl permitted 1 packets on intf po44  [SA:0001.0300.0400,DA:0001.0300.0500, 
Type:86dd, VLAN:100, SIP:fe80::201:3ff:fe00:400, DIP:3555:5555:6666:6666:7777:7777:8888:8888, 
l3_proto:udp, src_port:63, dst_port:63]