Resets all port-related configurations to factory defaults for the specified ports.
|
ports | Specifies all ports. |
| port_list | Specifies one or more ports or slots and ports. |
| configuration | Specifies to reset selected port configuration to factory defaults, including VLAN/VR membership, load sharing, policies and all per-port settings for protocols and features. |
N/A.
Use this command to reset all configuration settings for the specified ports to factory defaults. This includes VLAN/VR membership, load sharing, policies, and all per-port settings for protocols and features. The port configuration is restored to the same state as immediately after an unconfigure switch command.
A maximum of 10 ports can be specified in a single reset command. Consecutive reset commands must have at least a 5-second interval; commands executed within 5 seconds of the previous reset are rejected.
The command displays a confirmation prompt before execution to prevent accidental configuration loss:
Warning: This will restore factory defaults to all port-related configuration for selected port(s). Do you wish to proceed? (y/N)
Enter y or Yes to proceed with the operation.
The following command resets port 1 configuration to factory defaults:
unconfigure ports 1 configuration
The following command resets ports 1 through 8 to factory defaults:
unconfigure ports 1-8 configuration
This command was available in version 33.6.1.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, and X695 series switches.