This commands displays the IP device tracking configuration parameters for specified ports or all ports. Shows whether IP device tracking is enabled and the configured ARP probe parameters (interval, max-failures, initial-delay, and source IP address).
| nodealias | Node Alias feature that maps source IP address, MAC address, and protocol on a per port basis. |
| ip-device-tracking | Specifies IP device tracking information. |
| configuration | Specifies to show IP device tracking configuration. |
| ports | Specifies information on the ports for the Node Alias feature. |
| port_list | Specifies for which ports to display information. Designated as a port list separated by comma (,) or dash (-). |
If the ports are not specified, information appears for all ports.
Use this command to verify IP device tracking settings before enabling the feature.
Displays both enabled/disabled status and all ARP probe parameters.
Helpful for auditing configuration across multiple ports.
Compare settings across ports to ensure consistency in multi-port deployments.
The following example shows configuration for specific ports:
sh nodealias ip-device-tracking configuration ports 3:14
Port IP Device Max Probe Initial Probe
Tracking Failures Interval Delay Sender IP
------ --------- -------- -------- ------- ---------------
3:14 On 1 32 10 0.0.0.0
This command was first available in version 33.6.1.
This command is available on X440-G2, X450-G2, X460-G2, and X465 series switches.