logical-intf isis

Create a logical IS-IS interface.

Syntax

Command Parameters

<1-255>
Specifies the IS-IS logical interface ID.
dest-ip {A.B.C.D}
Specifies the destination IP address for the logical interface.
mlt PT_MLT<1-512>
Specifies the MLT ID that the logical interface is connected to in a Layer 2 network.
name WORD<1-64>
Specifies the administratively-assigned name of this logical interface.
port {slot/port[/sub-port]}

Identifies a single slot and port. If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

primary-vid <2-4059>
Specifies the primary tunnel VLAN ID associated with this Layer 2 IS-IS logical interface.

Specifies the VLAN ID in the range of 2 to 4059. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. By default, the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998.

vid {vlan-id [-vlan-id][,...]}
Specifies the list of VLANs that are associated with this logical interface.

The VLAN ID is in one of the following formats: A single VLAN ID (vlan-id), a range of VLAN IDs [(vlan-id)-(vlan-id)] or a series of VLAN IDs (vlan-id, vlan-id, vlan-id).

Default

None.

Command Mode

Global Configuration