Install Tunnel Concentrator

Use this procedure to load and install the Tunnel Concentrator application on the Universal Compute Platform.
  1. Log in to the Universal Compute Platform.
  2. Go to Engines > Image Management.
  3. Locate the image file on your desktop.
  4. Drag the image file onto the Universal Compute Platform desktop.
    The install file uploads automatically.
  5. Go to Engines > Installation.
  6. From the Extreme Tunnel Concentrator pane, select Install.
  7. In the popup window, select OK.
    A new instance of Tunnel Concentrator displays on the Engines page along with a link.
  8. Within the Extreme Tunnel Concentrator pane, select the link for your installation.
  9. Configure the following settings:
    • Node Affinity—Select the Universal Compute Platform node on which this Tunnel Concentrator instance will run.
    • Port 1—Virtual function 01 on port 1 is used for licensing.
      Note

      Note

      The Tunnel Concentrator instance is locked to the VF number.
    • Port (2, 3 and 4)—You can set these ports to any VF option.
  10. Select Deploy.
    After a delay of up to a few minutes to process the updates, the Extreme Tunnel Concentrator screen displays a set of four tabs.
  11. Under the Network Service Configuration tab, select the Assigned Virtual IP Address drop-down and select an IP address for the Tunnel Concentrator service. This IP address also gets used to generate a URL for GUI access.
  12. Select Save.
    After a few minutes, the screen displays an Instance web interface link.
  13. Select the Instance web interface link to launch the Extreme Tunnel Concentrator GUI.
  14. Log in using the default admin credentials.
    Note

    Note

    As a best practice, change the admin password immediately after the first login.
9038930-00 Rev. AA