Before you begin
Perform any necessary configuration changes at the device level. After you save these
changes, an exclamation mark displays in the device Status column, indicating the
device configuration is now out of sync with the network policy.
About this task
Use this task to push any configuration changes made at the device level to the
specific device, which will replace the exclamation mark with a green check.
ExtremeCloud IQ also allows you to upgrade the device in two ways:
- Via on the Devices List page
- Via on the Configure page.
Procedure
-
Select the device(s) to update
in the Devices List.
-
Select Update Devices.
-
If on the Configure page, select
Update.
-
Select Delta
Configuration Update.
-
Select Perform
Update.
The status icon changes
from an exclamation mark to a green check.
-
If you receive an out-of-sync error, hover over the
message and review the details to reveal where the local configuration is out of
sync.
-
Match the out-of-sync local configuration within the network policy,
switch template, or device level configuration and perform an update
device again.
-
If Step a is not successful, select Perform delta
configuration update and resolve local device configuration which is
out of sync with ExtremeCloud IQ.
Note
This option requires a minimum version of Switch Engine 32.3 and
Fabric Engine 8.9 installed on the switches.
