Input Parameters on Single-Node Install or Upgrade

This topic describes the input parameters for a single-node EFA deployment.

Note

The deployment parameters, such as -m or -f have been replaced with ?.

Minimum Required Commands

Following is the minimum required command for a single-node EFA deployment:

efa deploy non-interactive single-node package <package-name>

For example,

efa deploy non-interactive single-node package /efaboot/efa-2.7.1-tar.gz

Management IP Networks

Use the management-ip command if you need additional management IP networks.

efa deploy non-interactive single-node package /efaboot/efa-2.7.1-tar.gz management-ip sub-interface-name sub200 sub-vlan-id 200 external-subnet 10.20.246.99/20

Do not use the management-ip command if it is not required. EFA supports only adding a single sub-interface.

When deploying the management IP, the command sub-interface-name requires the name of the sub-interface. sub-vlan-id, which is the VLAN ID, and external-subnet, which is the external subnet address in CIDR format.