Enable Load Balancing

About this task

NPB application supports GTP tunnel ID based load balancing.

Procedure

  1. Enter interface port-channel configuration mode.
    Device# configure terminal
    Device#(config)# interface port-channel 1
    Device(config-if-po-1)#
  2. Enable load balancing.
    Device(config-if-po-1)# load-balance src-dst-ip-l4port
    Note

    Note

    For tunnel ID based load balancing, go to step 3.
  3. Enable tunnel ID based load balancing.
    Device(config-if-po-1)# load-balance src-dst-ip-l4port-tid