About this task
You can use the mirror reference in
ingress group to enable mirroring based on filters.
Procedure
-
Enter the Config
mode.
device# configure terminal
device(config)#
-
Enter the mirror configuration
mode.
device(config)# mirror mirr_1
device(config-mirror)#
-
Configure the mirror destination
port in slot/port format.
device(config-mirror)# set interface ethernet NAME
Only one mirror destination
port is supported.
Example
The following example shows the configuration of a mirror to an
ingress-group:
9920(config)# mirror mirr_1
9920(config-mirror)# set interface ethernet 1/10
9920(config-mirror)# do show mirror mirr_1
Name : mirr_1
Description : -
Interface : ethernet 1/10
9920(config-mirror)# ingress-group vv1
9920(config-ingress-group)# traffic-type vxlan outer mirror mirr_1
9920(config-ingress-group)# do show ingress-group vv1
Name : vv1
Route-Map : -
Description : -
Interfaces : none
Outer Tunnel Config :
Traffic-Type : VxLAN
Tunnel-Id : any
Destination-ip-addr : any
Source-ip-addr : any
Mirror : mirr_1
