Install an AC Power Supply

Up to four 1,600 watt power supply modules can be installed in the Extreme 9920 chassis. Each power supply is self enclosed and vents directly to the rear of the chassis. If the chassis has more than two power supplies installed, power supplies are hot-swappable. The power supply slots are situated in the four contiguous slots starting from the left-hand side to the bottom and the rear of the chassis. They are numbered PSU 1 through PSU 4.

Note

Note

Do not remove the cover from the fifth, or last, power supply slot on the far right to the bottom and the rear of the chassis.

The AC power supply does not ship installed and must be ordered separately.

Note

Note

Electrostatic discharge (ESD) can damage electronic circuits. Do not touch electronic hardware unless you wear a grounding wrist strap or other static-dissipating device.

  1. Identify the power supply slot in the chassis to install the power supply module, and remove the filler panel, if necessary.
  2. Verify that the power supply is right side up by orienting the power supply so that the green tabbed release lever is on the right-hand side.
  3. Slide the power supply into the power supply slot, until the release lever locks the power supply in place and the power supply is properly seated.
    Click to expand in new window
    Inserting an AC power supply into the Extreme 9920
    Inserting an AC power supply into the Extreme 9920
  4. Connect the AC power cord and secure it using the retention clip as the provided cable management.
  5. Repeat these steps for each power supply.