After you have installed the AC power supply into the chassis, use the following procedure to attach the retention clip and connect the AC power cord to an AC power source.
Obtain AC power cords to match the power service conventions for your country (one for each power supply).
Locate the retention clip (supplied) for use with straight-ended power cords.
Warning
Use AC power cords that have a ground wire (if applicable). If you use power cords without a ground wire, ensure the switch is properly grounded before powering on the unit. Without a proper ground, you are in danger of receiving an electrical shock. Lack of a grounding path to the switch can result in excessive emissions.
Tip
Power cable plugs vary in size so when you extend the retention strap to its full length, you can accommodate most plug sizes.
Important
The chassis does not have an AC power switch. After you connect the power cord to an AC power outlet, the switch powers up immediately.
Both LED lights for the AC power supply units show steady green when connected and operating normally.