Display Auto-sense Configuration on the Switch

About this task

Perform this procedure to display the Auto-sense configuration on the switch.

Procedure

  1. To enter User EXEC mode, log on to the switch.
  2. Display the Auto-sense configuration:

    show auto-sense [access-differv] [data] [dhcp-detection] [eapol] [fa] [isis] [onboarding] [qos] [sd-wan] [voice] [wait-interval]

  3. Display the Auto-sense status and state on a port:

    show interfaces gigabitEthernet auto-sense [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

Examples

Display the Auto-sense status for Fabric Attach (FA):

Switch:1>show auto-sense fa
==================================================================================
                                   AUTO-SENSE FA Config
==================================================================================
MSG-AUTH                       MSG-AUTH-KEY
----------------------------------------------------------------------------------
enabled                        ****
----------------------------------------------------------------------------------

==================================================================================
                           AUTO-SENSE FA Client specific config
==================================================================================
TYPE                EAPOL STATUS    I-SID   VLANID  C-VID  MGMT I-SID MGMT C-VID
----------------------------------------------------------------------------------
camera              Auto            100     100    untag   -          -  
wap-type1           Auto            200     200    untag   -          -
open-virtual-switch Auto            -       -      -       -          -
proxy-no-auth       Auth            300     300    untag   -          -
proxy               Auth            400     n/a    400     400        400
----------------------------------------------------------------------------------
 6 out of 6 Total Num of AUTO-SENSE entries displayed
----------------------------------------------------------------------------------

Display the Auto-sense configuration related to ExtremeCloud SD-WAN:

Switch:1>show auto-sense sd-wan
==========================================================================================
                                 AUTO-SENSE GLOBAL Config
==========================================================================================
SDWAN
MULTI-AREA
------------------------------------------------------------------------------------------
REMOTE
------------------------------------------------------------------------------------------

==========================================================================================
                  AUTO-SENSE SD-WAN Logical Interfaces Multi-Area Config
==========================================================================================
DEST-IP            MULTI-AREA
------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------
10.10.10.10        REMOTE
20.20.20.20        HOME
30.30.30.30        REMOTE
------------------------------------------------------------------------------------------
4 out of 4 Total Num of AUTO-SENSE entries displayed
------------------------------------------------------------------------------------------

Display the Auto-sense configuration related to voice:

Switch:1>show auto-sense voice
===============================================================================
                              AUTO-SENSE VOICE Config
===============================================================================
TYPE   LDDP-AUTH ENABLE I-SID      C-VID      DSCP       PRIORITY
-------------------------------------------------------------------------------
phone  FALSE            2000       2000       46         6
-------------------------------------------------------------------------------
1 out of 1 Total Num of AUTO-SENSE entries displayed
-------------------------------------------------------------------------------

Display the global Auto-sense wait-interval information:

Switch:1>show auto-sense wait-interval
============================================================================
                                 AUTO-SENSE GLOBAL Config
============================================================================
WAIT
INTERVAL
----------------------------------------------------------------------------
50
----------------------------------------------------------------------------

----------------------------------------------------------------------------
0 out of 0 Total Num of AUTO-SENSE entries displayed
----------------------------------------------------------------------------

Display the Auto-sense status and state on a range of ports:

Switch:1>enable
Switch:1#show interfaces gigabitethernet auto-sense 1/1-1/5
======================================================================
                                Port Auto-sense
======================================================================
----------------------------------------------------------------------
PORT     AUTO-SENSE   AUTO-SENSE         AUTO-SENSE       AUTO-SENSE
NUM      STATUS       STATE              PORT-DATA-ISID   PORT-WAIT-INTERVAL
----------------------------------------------------------------------
1/1      Enable       FA-PROXY-RING      --               20
1/2      Enable       SD-WAN              --              10
1/3      Enable       DOWN               --               10
1/4      Enable       DOWN               --               10
1/5      Disable      OFF                --               10