The Bridge MIB module for managing devices that support IEEE 802.1D.
The Bridge-Identifier, as used in the Spanning Tree Protocol, to uniquely identify a bridge. Its first two octets (in network byte order) contain a priority value, and its last 6 octets contain the MAC address used to refer to a bridge in a unique fashion (typically, the numerically smallest MAC address of all ports on the bridge.
The following groups from LLDP-EXT-DOT1-MIB are fully supported.
| Object group name | OID | Supported? |
|---|---|---|
|
dot1dBase |
1.3.6.1.2.1.17.1 |
Yes |
|
dot1dStp |
1.3.6.1.2.1.17.2 |
Yes |
|
dot1dTp |
1.3.6.1.2.1.17.4 |
Yes |
|
dot1dStatic |
1.3.6.1.2.1.17.5 |
Yes |
Note
The dot1dTpFdbTable (OID 1.3.6.1.2.1.17.4.4) in RFC 1493 is used to find dynamically learned MAC addresses. Statically configured MAC addresses are in the snFdbTableNote
The SNMP MIB object dot1dStpPortTable (OID 1.3.6.1.2.1.17.2.15) does not display information for tagged ports that belong to an 802.1W RSTP configuration. The design of that MIB table is based on a Single STP standard, and does not accommodate Multiple STPs. Thus, the table displays information only for SSTP and for tagged and untagged ports.Note
RFC 4188 has been converted to SMIv2 format. The object dot1dStpPortPathCost32 was added to support IEEE 802. The existing MIB dot1dStpPortPathCost has an upper range of 65535. Over that value, this MIB stays at the upper value and you should access dot1dStpPortPathCost32, which has a higher upper-range value.