Attach the Access Point to a Pole Using WS-MBO-POLE01 Bracket and MBO-ART02 Articulating Mounting Bracket

Before you begin

Note

Note

The WS-MBO-POLE01 bracket is End of Sale (EOS) as of January, 2023.

The MBO-ART02 wall mount bracket is End of Sale (EOS) as of January, 2023. It is replaced by the MBO-ART03 bracket.

For more information, see End of Sale and End Service Life.

The following hardware is required:

WS-MBO-POLE01 bracket
MBO-ART02 bracket
Two M6 hex-head screws
Four M3 screws, nuts, and washers to attach the WS-MBO-POLE01 bracket to the MBO-ART02 articulating mounting bracket
Two cable clamps
Note
You need to provide your own stainless-steel cable clamps. The band must be 0.5 in. (12.7 mm) wide.
Access point

Procedure

Attach the MBO-ART02 articulating mounting bracket to the access point using two M6 hex-head screws.
Attach the WS-MBO-POLE01 bracket to the MBO-ART02 articulating mounting bracket using four M3 screws, nuts, and washers.

POLE01 bracket being attached to the ART02 articulating mounting bracket
Open the cable clamp by turning a flat-bladed screwdriver counterclockwise.
Insert the non-clamp end into the pole bracket through the holes.
Attach both the cable clamps to the WS-MBO-POLE01 bracket.
Place the metal band around the pole, and attach the WS-MBO-POLE01 bracket to the pole.
Tighten the cable clamp screw clockwise, tightening the band around the pole.

Tightening the cable clamp around the pole

AP360i access point attached to a pole using MBO-ART02 articulating mounting bracket and POLE01 bracket

9036628-02 Rev AA