Install the Access Point on a Flat T-bar Using the DCFLUSH bracket

Before you begin

Ensure that the T-bar meets the following conditions before installing the DCFLUSH bracket on it:

  • T-bar width must be 9/16 in. (15mm), 15/16 in. (24mm), or 1.5 in. (38 mm).
  • T-bar bottom must be flat all the way across.
  • T-bar must be structurally sound.
  • T-bar maximum base thickness must not exceed 0.080 in. (2.000 mm).
  • Ceiling tile must be flat all the way across.
  • Maximum ceiling tile protrusion allowed is 0.015 in. (0.380 mm).

About this task

The WS-MBI-DCFLUSH (#37211) bracket is used on a flat T-bar when you do not want to use the main mounting bracket or have a 9/16 in. wide or 1.5 in. wide T-bar.

Procedure

  1. Remove the ceiling panels around the T-bar.
  2. Open the movable sliding part of the DCFLUSH bracket to give the stationary and slider T-bar more space.
    Click to expand in new window
    DCFLUSH bracket parts and T-bar
    Image of the DCFLUSH bracket being slid onto a T-bar.
    Callout Description
    1 T-bar
    2 Movable sliding part of the DCFLUSH bracket
  3. Hook the stationary end of the bracket onto the T-bar.
  4. Tilt the T-bar up slightly in such a way that you are holding the stationary and movable parts of the bracket.
  5. Squeeze the bracket parts together until you hear the T-bar locking tab click into place.
  6. Slide the bracket base into the rear groove of the access point.
  7. Hold and rock the access point back and forth to ensure that it is securely mounted.
  8. Attach the RJ45 connector to the GE1 port.
  9. Replace the ceiling tiles.
9036459-04 RevAA