Install a Security Torx Locking Screw

About this task

The security torx locking screw is used to prevent the access point from being removed from the main mounting bracket (#37201). There are two security lock screw holes on the rear of the access point.
Note

Note

Perform this task after the access point is attached to the main mounting bracket on drywall or wood wall.
Note

Note

You cannot remove the access point from the main mounting bracket until the security torx locking screw is removed.

Procedure

  1. Line up the security torx locking screw using the rear guides on the access point.
  2. Using a T8 bit screwdriver, tighten the security lock screw.
  3. Turn the locking screw into the integral security screw hole until the security torx locking screw passes through the other side.
    Click to expand in new window
    Attach a security torx locking screw on the access point
    Image of a stainless-steel bracket being attached to the back of an access point. The security torx locking screw is attached on the side of the access point.
    Callout Description
    1 Stainless-steel main mounting bracket attachment to the access point
    2 Security torx locking screw to keep the bracket in place
9036459-04 RevAA