Install the Access Point Using the WALL04 Bracket

About this task

The optional WALL04 (#30516) bracket is used for wall installations, and ships with two Phillips pan head screws and two screw-in anchors. You must purchase the bracket separately.

Note

The locking tab on the WS-MBI-WALL04 bracket must be on the top side during installation.

Procedure

Using the WALL04 bracket as a template, mark and drill two holes on a wall.

Tip
The best practice is to use the "A" and "B" hole templates on the WALL04 bracket to mark the attachment holes.

Note
When using the "A" or "B" hole template, if the holes are not near the corners of the bracket, you can break off the corner to minimize the amount of bracket that is visible behind the access point.
Attach the WS-MBI-WALL04 bracket on a wall using two Phillips pan head screws.

Tip
The best practice is to install the screw-in anchors before attaching the pan head screws during drywall installations.
Connect the GE1 cable to the access point.
Insert the access point into the WALL04 bracket keyhole posts and slide it into place.
Lock the access point at approximately 1/4^th in. from the bracket.