You can use the upgrade process to
replace a faulty node in a multi-node TPVM deployment.
Before you begin
- Ensure that the cluster with faulty node is
running EFA 2.5.5 or later.
- Ensure that you have completed the
high-availability prerequisites described in .
- Ensure that XCO is not deployed on the
replacement node.
About this task
During node replacement process, the faulty node is decommissioned, the replacement node is
provisioned, and the active node is reconfigured to form a cluster.
Perform this procedure on the active node where XCO is installed.
Procedure
-
Enter SLX Linux mode and copy
the XCO tar file to the SLX device.
device# start-shell
scp <username>@<hostip>:<buildpath>/efa-3.1.0.tar.gz
-
Deploy XCO on TPVM from the SLX shell.
device# efa deploy
Starting "efa deploy", DO NOT hit CTRL+C
Step 1: Checking if TPVM is deployed ...
Step 2: Get IP Addressed assigned to TPVM to deploy EFA
IP Address of the TPVM 10.x.x.x
Step 3: Checking for EFA packages in /efaboot directory
Step 4: Deploying EFA package efa-2.x.x.tar.gz on 10.x.x.x
The XCO Installer begins in a series of dialogs.
-
When prompted, select Multi Node Build Upgrade with
Node Replacement and OK.
Tip
Use arrow keys to move between
options. Press the space bar to select an option.
-
When prompted, enter the IP
address or host name of the replacement peer node and select
OK.
As the node replacement proceeds,
messages display showing the replacement progress.
-
Verify the status of XCO after the node replacement.
device# sudo efactl status
