show flowmon collector

show flowmon collector [collector_name | all] detail

Description

Displays Flow Monitor collector information.

Syntax Description

collector Specifies to send flow information to a collector.
collector_name Specifies the name of the created collector. Range is 32 characters.
all Specifies to show Flow Monitor information for all collectors.
detail Specifies to show all information associated with the specified collector.

Default

N/A.

Usage Guidelines

If detail is entered, the source and destination IPv4 addresses, source and destination UDP ports, VR name, and export MTU size are displayed.

If collector_name is not entered, then a list of collectors is displayed.

Example

The following command displays detail information for a collector with the name 'c1':

# show flowmon collector c1 detail 
Name                                    : c1
Destination IP address                  : 11.1.1.100
Virtual Router                          : VR-Default (default)
Source IP address                       : 11.1.1.1
Source UDP port                         : 46562 (default)
Destination UDP port                    : 4739 (default)
Export MTU                              : 512 (default)
Refresh time                            : 600 (default)
* (pacman debug) 5420F-24T-4XE-SwitchEngine.13 #

* (pacman debug) 5420F-24T-4XE-SwitchEngine.13 # show flowmon key k1 detail 
Name                                    : k1
Type                                    : IPv4
Group                                   : g1
Destination IP address                  : 11.1.1.101

History

This command was first available in ExtremeXOS 32.2.

Platform Availability

This command is available on ExtremeSwitching 5420, 5520, and 5720 series switches.