Mounting to a Junction/Gang Box

About this task

Mounting the AP7632 to a junction/gang box requires a WS-MBI-WALL04 bracket, which must be purchased separately (ordering Part Number 30516).

Remove the screws from the junction/gang box.
Line up the bracket holes on the junction/gang box and ensure that they align. If the holes do not align, drill new holes.

Note
When you line up the holes, the locking tab on the bracket must be pointing down and the junction/gang box must be fully covered by the bracket. The bracket must be square to the rest of the room walls and the two holes that are being used must be on the opposite side of large center hole on the bracket.

Note
If the holes that you need to use are not near the corners of the bracket, break off the corner to decrease bracket‘s visibility once the AP is installed.
Using the holes aligned together or the new ones drilled, attach the bracket to the junction/gang box using the screws removed from the junction box earlier. Do not over tighten.

Caution
Over tightening the screws will cause the bracket to bend. If the bracket bends, you will not be able to align and slide the AP onto the keyhole posts.
Connect the LAN/Ethernet cable to the AP.
Align the keyhole slots and posts and slide the AP onto the bracket until you hear it lock in place.