Installation Process

The installation process lists the steps that the user will need to follow to successfully install the AP7632 access point.

About this task

Follow this procedure to install AP7632:

Note

Note

For console cables which are permanently attached to the Access Point, use the following guidance. When using twisted pair cable, the installer should not wire the cables as one normally would for RJ-45 (e.g. Ethernet). Rather the installer should wire them so that wires 3:4 and 5:6 make pairs. Other pairings of wires 3 and 6 will be susceptible to data signal crosstalk. The pairing of the remaining wires is not important, but 1:2 and 7:8 is commonly used.

Procedure

  1. Verify the Box Contents.
  2. Read the Safety Guidelines.
  3. Read the Professional Installation Instructions.
  4. Mount the AP to a Flat Ceiling. Alternatively, you can also mount the AP to a junction/gang box, or a suspended/drop ceiling.
    Note

    Note

    An optional Flat Metal Indoor Bracket can be purchased (ordering Part Number 37210) for easy installation to a flat ceiling/wall.
    Note

    Note

    The AP can also be mounted to a flat wall/ceiling using the WS-MBIWALL04 (ordering Part Number 30516) bracket.
    Note

    Note

    Mounting the AP to a suspended or drop ceiling requires the optional adapter (Universal Mounting Kit for EWLAN APs; purchasing part number KT-135628-01), which must be purchased separately.
    Note

    Note

    The optional WS-MBI-DCMTR01 (purchasing part #30518) adaptor can also be used for T-bar installations onto suspended/drop ceiling.
  5. Connect the Power Supply to the AP7632 access point.
9035132-01