Push the Device-Level Configuration to the Device

Perform any necessary configuration changes at the device level. After you save these changes, an exclamation mark displays in the device Status column, indicating the device configuration is now out of sync with the network policy.

Use this task to push any configuration changes made at the device level to the specific device, which will replace the exclamation mark with a green check. ExtremeCloud IQ also allows you to upgrade the device in two ways:

Go to Manage > Devices > Update Devices on the Devices List page
Go to Manage > Devices > host_name > Update on the Configure page.

Select one or more devices to update in the Devices List.
Select Update Devices.
If on the Configure page, select Update.
Select the option Perform delta configuration update and resolve local device configuration which is out of sync with ExtremeCloud IQ.
Select Perform Update.
The status icon changes from an exclamation mark to a green check.
If you receive an out-of-sync error, hover over the message and review the details to reveal where the local configuration is out of sync.
1. Match the out-of-sync local configuration within the network policy, switch template, or device level configuration and perform an update device again.
2. If Step a is not successful, select Perform delta configuration update and resolve local device configuration which is out of sync with ExtremeCloud IQ.
  
  Note
  The option Perform delta configuration update and resolve local device configuration which is out of sync with ExtremeCloud IQ requires a minimum version of Switch Engine 32.3 and Fabric Engine 8.9 installed on the switches.