Create a complete network policy configuration.
When you create a new network policy or make changes to an existing policy, the final
step is to push the policy to the devices that will operate under the policy.
ExtremeCloud IQ pushes all configuration uploads as complete uploads. This requires
devices to reboot and activate the new configurations.
-
Navigate .
-
Select a policy that is ready to deploy.
-
Select the Deploy Policy tab.
-
To upload a network policy to
all of the devices in the devices list, select the check box in the top left
side of the table header.
This automatically selects the
check boxes for all of the devices.
-
Select Upload.
-
To upload your network policy to specific devices only, select the check box
for those devices, and then select Upload.
You can filter the devices displayed with the Assigned,
Eligible and Filtered
options.
-
In the Device Update window, select the type of update
(Delta or Complete), whether
to update IQ Engine and Extreme Networks switch images, and the activation times
for the updated devices.
-
You can optionally select Reboot and revert Extreme Networks switch
configuration if IQAgent is unresponsive after configuration
update under Update Network Policy and
Configuration.
Select this option to revert the switch configuration if the device update
causes a disconnect between the switch and ExtremeCloud IQ. The switch reboots
and reverts to its previous configuration, which enables you to correct any
configuration issues and perform a new device update.
-
Select Perform Update.
