Use these steps to configure VLAN settings on the Port
Configuration page.
-
Select the add icon.
-
Enter the name of the new
VLAN.
-
Enter the VLAN ID for this
VLAN.
Typically, the default VLAN ID is 1.
Note
You can also create a VLAN ID with a value of
none.
None clears the native VLAN from a port. (Switch
Engine device only)
-
Select Apply VLAN to devices for
classification to create VLANs that you can apply to specific
devices based on their location.
-
Select the plus sign.
-
Enter the new VLAN ID.
-
Select Add to add the ID
to the VLAN table.
-
Under Classification
Rules in the VLAN table, select an existing classification rule,
or select the add icon to add a new rule.
-
Select Link.
-
Enter a name for the
classification rule.
For easier tracking, you might want to add the locations and device models
using this VLAN classification rule (for example, VLAN-AP230-Sunnyvale).
-
Enter an optional description.
-
Select the plus sign to choose
the device location.
-
Assign your VLAN profile based on the location of managed devices.
Note
When selecting a location, drill down to the level where the devices are
located. For example, if the devices are located on the floor of a building,
select that specific floor.
-
Choose Select.
-
Select Save VLAN.
