show ipconfig ipv6

show ipconfig ipv6 {vlan vlan_name | tunnel tunnel_name}

Description

Displays configuration information for one or more interfaces in the current VR context.

Syntax Description

vlan_name Specifies an IPv6 configured VLAN.
tunnel_name Specifies an IPv6 tunnel.

Default

N/A.

Usage Guidelines

If no interface is specified, then global IPv6 configuration is displayed. Otherwise, specific interface(s) will be displayed. Global IPv6 configuration information includes:
  • IPv6 address/netmask/etc.
  • IPv6 forwarding information/IPv6 multicast forwarding information

Example

The following example displays configuration information on a VLAN "accounting":

show ipconfig ipv6 vlan accounting

The current and configured values for max-gateways now apply to IPv6 gateway sets as well as IPv4, so these values are added to the output:.

# show ipconfig ipv6  
Route Sharing : Disabled    
ICMP Redirect for Fast Path : Disabled    
Max Shared Gateways : Current: 32 Configured: 32

The configuration settings for static route ping protection enable/disable, interval, and misses also appear:

# show ipconfig ipv6
Route Sharing : Enabled
Route Compression : Enabled
ICMP Redirect for Fast Path : Disabled
Max Shared Gateways : Current: 16 Configured: 16
Route Sharing Hash : CRC Lower
Ping Protection : Enabled for static routes Interval: 2 Misses: 3
IPV6 Anycast MAC            : 00:00:AB:BA:BA:BA

History

This command was first available in ExtremeXOS 11.2.

This command changed to display information for the current VR context in ExtremeXOS 12.5.

The show output for max-gateways was added in ExtremeXOS 15.3.

Ping protection information added in ExtremeXOS 22.1.

Route sharing hashing algorithm (default or custom) added in ExtremeXOS 22.1.

IP anycast information was added in ExtremeXOS 30.6.

Platform Availability

This command is available on the platforms listed for the IPv6 unicast routing feature in the ExtremeXOS 30.7 Feature License Requirements document.