Displays link-fault-signaling information.
Exec mode
This command is available only to users with admin role.
This command is not allowed on management interface.
The following example shows how to configure link-fault-signaling on a device.
device(config)# int e 1/1-16,2/1-16 device(config-if-eth-1/1-16,2/1-16)# no link-fault-signaling devicedevice(config-if-eth-1/1-16,2/1-16)#
The following example shows link-fault-signaling information.
device# show link-fault-signaling
Port Link-Fault
========== ===============
Eth 1/1 OFF
Eth 1/2 ON
Eth 1/3 ON
Eth 1/4 ON
Eth 1/5 ON
Eth 1/6 ON
Eth 1/7 ON
Gnmi set on management port –