Displays content of the active or latest PCAP file.
Exec mode
The active PCAP file is updated at an interval of 10 seconds.
This command can decode and display packets with the following headers: ARP, Dot1Q, EAPOL, Ethernet, GTP, ICMP, ICMPv6, IPv4, Ipv6, LACP, LLC, LLDP, TCP, and UDP.
The following example shows content of the active PCAP file.
device# show capture packet interface all ------------------------------------- Frames Logged on interface = All ------------------------------------- ---------------------------------------------------- Pkt Capture Metadata: #1 of 1 Packets --------------------:------------------------------- Frame Received Time : Fri, 04 Dec 2020 20:25:02 UTC Packet Length(bytes) : 64 Packet Direction : RX Packet Filter : All Front Panel Port : 1/1 ---------------------:-------------------- ETHERNET HEADER : ---------------------: SrcMAC : 00:00:11:da:4d:72 DstMAC : 00:00:00:f0:c9:b9 EtherType : IPv4(0x800) ---------------------:-------------------- IPv4 HEADER : ---------------------: Src IP Address : 1.0.10.2 Dst IP Address : 1.0.10.1 Type of service : 0 Total Length : 28 Bytes Identification : 0x0 Fragmentation : 0 TTL : 64 Protocol : ICMPv4(1) IP Checksum : 0x24df ---------------------:-------------------- ICMP DETAILS : ---------------------: ICMP Hdr Type : EchoRequest ICMP Hdr Code : 0x0 ICMP Hdr Checksum : 0xf7f7 ICMP ID : 0x0 ICMP Sequence No : 0x8 ---------------------:-------------------- --More--