Extreme Discovery Protocol (EDP) Enabled on
Management Port
Extreme Discovery Protocol (EDP) is now enabled on the management port. Prior to ExtremeXOS 30.1, EDP was
not available on the management port.
EDP is useful when Extreme Networks switches are attached to a port. EDP is used to locate
neighbor Extreme Networks switches and exchange information about switch configuration.
When running on a normal switch port, EDP is used to by the switches to exchange
topology information with each other. Information communicated using EDP includes the
following:
- Switch MAC address (switch
ID)
- Switch software version
information
- Switch IP address
- Switch VLAN information
- Switch port number
- Switch port configuration data:
duplex, and speed
Supported Platforms
Summit X450-G2, X460-G2, X670-G2, and ExtremeSwitching X440-G2, X620, X690, X870
series switches.
Changed CLI Commands
The following commands can now enable/disable EDP on the management port:
enable edp ports [ports | all]
disable edp ports [ports | all]