show ipv6 bgp neighbors

Displays configuration information and statistics for BGP4+ neighbors of the device.

Syntax

show ipv6 bgp neighbors [ ipv6-addr ]

show ipv6 bgp neighbors last-packet-with-error [ vrf vrf-name ]

show ipv6 bgp neighbors routes-summary [ vrf vrf-name ]

show ipv6 bgp neighbors vrf vrf-name

Parameters

ipv6-addr: IPv6 address of a neighbor in dotted-decimal notation.
last-packet-with-error: Displays the last packet with an error.
route-summary: Displays routes received, routes accepted, number of routes advertised by peer, and so on.

vrf vrf-name: Specifies a VRF instance.

Modes

Privileged EXEC mode

Usage Guidelines

Use this command to view configuration information and statistics for BGP4+ neighbors of the device. Output shows all configured parameters for the neighbors. Only the parameters whose values differ from defaults are shown.

Examples

This example shows sample output from the show ipv6 bgp neighbors command.

device# show ipv6 bgp neighbors

    Total number of BGP Neighbors: 1
1   IP Address: 1:2::3, AS: 100 (IBGP), RouterID: 0.0.0.0, VRF: default-vrf
    State: CONNECT, Time: 0h3m3s, KeepAliveTime: 60, HoldTime: 180
    Minimal Route Advertisement Interval: 0 seconds
    Messages:    Open    Update  KeepAlive Notification Refresh-Req
       Sent    : 0       0       0         0            0          
       Received: 0       0       0         0            0          
    Last Connection Reset Reason:Unknown
    Notification Sent:     Unspecified
    Notification Received: Unspecified
    Neighbor NLRI Negotiation:
      Peer configured for IPV6 unicast  Routes
    Neighbor ipv6 MPLS Label Capability Negotiation:
    Neighbor AS4 Capability Negotiation:
    Outbound Policy Group:
       ID: 2, Use Count: 3
       Last update time was 172 sec ago
Error: TCP status not available