Bypass LSP Statistics

About this task

Bypass tunnel statistics measure the amount of traffic pushed into the bypass tunnel. It accounts the traffic for both tunnels and transit which are in a repaired state and using the bypass tunnel to forward traffic.

The user can enable bypass LSP statistics with the ingress-tunnel-accounting command.

To enable bypass LSP statistics, complete the following steps.

Procedure

Enable the device for configuration.
```
device>configure
```
Enable the MPLS router.
```
device(config)# router mpls
```
Enter the policy mode.
```
device(config-router-mpls)# policy
```
Enable bypass LSP statistics with the ingress-tunnel-accounting command.
```
device(config-router-mpls-policy)# ingress-tunnel-accounting
```

Example

The following example combines the steps above to enable bypass LSP statistics using the ingress-tunnel-accounting command.

device>configure
device(config)# router mpls
device(config-router-mpls)# policy
device(config-router-mpls-policy)# ingress-tunnel-accounting

The user can display the statistics for bypass LSPs by using the show mpls statistics tunnel show command.

device# show mpls statistics tunnel
Tunnel                           Total           Since Last clear   Rate        
Index  LSP Name      Proto  Byp  Packets Bytes   Packets Bytes      Pkts/sec  Bytes/sec
     1 my-bypass-lsp    R   Yes        0     0         0     0             0         0 
     2 t2               R   No         0     0         0     0             0         0