Clear and Troubleshoot IPv6 MLD Information

Use clear commands to remove information about the internal state of IPv6 MLD. Use the debug command to enable debug flags for troubleshooting. You can run the commands from any level of the CLI. For more information, see the Extreme SLX-OS Command Reference.

Important

Diagnostic commands are developed and intended for specialized troubleshooting. Work closely with Extreme Networks technical support in running debug commands and interpreting their results.

Remove the accumulated information about learned groups for a specified bridge domain or VLAN.

device# clear ipv6 mld groups ?
Possible completions:
	<IPv6 address>
	bridge-domain   Bridge-Domain ID 
	vlan            Vlan interface
	|               Output modifiers
	<cr>
device# clear ipv6 mld groups
device# clear ipv6 mld groups ff28::1
device# clear ipv6 mld groups ff28::1 bridge-domain 10 
device# clear ipv6 mld groups ff38::2 vlan 100
device# clear ipv6 mld groups bridge-domain 10
device# clear ipv6 mld groups vlan 10

Remove the accumulated MLD statistics for a specified VLAN or bridge domain.

device# clear ipv6 mld statistics ?
Possible completions:
	bridge-domain   Bridge-Domain ID 
	vlan            Vlan interface
	|               Output modifiers
	<cr>
device# clear ipv6 mld statistics bridge-domain 100
device# clear ipv6 mld statistics vlan 100

Enable debug flags.

device# debug ipv6 mld ?
Possible completions:
	all         All
	errors      Errors
	group       Multicast group 
	interface   Interface information 
	l2-port     l2-port
	packet      packet
	rx          packet recieved
	tx          packet transmitted
	vlan        Vlan interface

device# debug ipv6 mld errors