threshold-monitor bfd-sessions
Configures monitoring of the number of BFD Session against the maximum number of
supported BFD sessions and alerts the user when configured thresholds are exceeded.
Syntax
threshold-monitor bfd-sessions
[
high-limit
value-in-percent
]
[
low-limit
value-in-percent
]
[
actions
[
none
|
raslog
|
snmp
|
all
]
]
no threshold-monitor bfd-sessions
Parameters
-
actions
[
none
|
raslog
|
snmp
|
all
]
- Specifies the action to be taken when a threshold is exceeded. The values
supported are
all, none,
raslog, and snmp. Default is
all.
-
all
- RASLOG and SNMP trap will be sent when the threshold is
exceeded.
-
none
- No action will be taken when the threshold is exceeded.
-
raslog
- Only RASLOG will be sent when the threshold is exceeded.
-
snmp
- Only SNMP traps will be sent when the threshold is exceeded.
-
high-limit
value-in-percentage
- Specifies the upper threshold limit of BFD sessions as a percentage (%) that
will trigger the configured action. The range is 10%-100%. The default value
is 90%.
-
low-limit
value-in-percentage
- Specifies the lower threshold limit of BFD sessions as a percentage (%) that
will trigger the configured action. The range is 10%-99%. The default value
is 70%.
Modes
Global configuration mode
Usage Guidelines
The no form of this command will reset the values to default.
The low-limit threshold value cannot be equal to or higher than the value
configured for the high-limit threshold value.
Examples
The following example configures the lower and higher
threshold monitoring values for the BFD sessions.
SLX# configure terminal
SLX (config)# threshold-monitor bfd high-limit 95 low-limit 50 action all
SLX (config)#
The following example resets the configured BFD session threshold
monitoring values to their defaults.
SLX# configure terminal
SLX (config)# no threshold-monitor bfd high-limit
SLX (config)# no threshold-monitor bfd low-limit
SLX (config)# no threshold-monitor bfd action
