threshold-monitor mac-table
Configures monitoring of the utilization of available MAC Table resources and alerts the user
when configured thresholds are exceeded.
Syntax
threshold-monitor mac-table
[
high-limit
value-in-percent
]
[
low-limit
value-in-percent
]
[
actions
[
none
|
raslog
|
snmp
|
all
]
]
no threshold-monitor mac-table
[
high-limit
|
low-limit
|
action
]
Parameters
-
high-limit
value-in-percentage
- Specifies the upper threshold limit of MAC Table utilization as a percentage (%)
that will trigger the configured action. The range is 10%-100%. The
default value is 70%.
-
low-limit
value-in-percentage
- Specifies the lower threshold limit of MAC Table utilization as a percentage (%)
that will trigger the configured action. The range is 10%-99%. The
default value is 50%.
-
actions
[
none
|
raslog
|
snmp
|
all
]
- Specifies the action to be taken when a threshold is exceeded. The values
supported are
all,
none, raslog, and
snmp. Default "action"
is "all".
-
all
- RASLOG and SNMP trap will be sent when the threshold is
exceeded.
-
none
- No action will be taken when the threshold is exceeded.
-
raslog
- Only RASLOG will be sent when the threshold is exceeded.
-
snmp
- Only SNMP traps will be sent when the threshold is exceeded.
Modes
Global configuration mode
Usage Guidelines
The no form of this command will reset the values to default.
The low-limit threshold value cannot be equal to or higher than the value
configured for the high-limit threshold value.
Examples
The following example configures the lower and higher threshold monitoring
values for the entries in the MAC Table.
SLX# configure terminal
SLX (config)# threshold-monitor mac-table high-limit 95 low-limit 50 action all
SLX (config)#
The following example resets the configured MAC table entries
threshold monitoring values to their defaults.
SLX# configure terminal
SLX (config)# no threshold-monitor mac-table high-limit
SLX (config)# no threshold-monitor mac-table low-limit
SLX (config)# no threshold-monitor mac-table action
