Install the Access Point

About this task

The access point can be installed on an outdoor environment on a vertical or horizontal pole, or to a flat surface. For more information about selecting the right access point for your installation needs, see Access Point and Accessory Box Contents and Order Information.

Note

The installation procedure for AP460C, AP460S6C, and AP460S12C access points are similar. The installation procedures covered in this document is applicable to all these access points.

Procedure

Verify the access point and accessory box contents based on your order information.
Visually inspect the access point, the bracket, and any other optional accessories you have ordered for physical damage.
If there is any damage, contact Extreme Networks Support.
Read and review the safety guidelines.
Select an access point and accessory mounting option:
- To install the access point on a vertical or horizontal pole, see Install the Access Point on a Vertical Pole or a Horizontal Pole Using the Built-in Bracket.
- To install the access point on a flat surface, see Install the Access Point on a Flat Surface Using the AH-ACC-BKT-ASM Accessory.
Tip
For best performance, deploy devices in open areas at least 100.0 ft. (30.5 m) apart from each other.
After installation, safely ground the access point.
Weatherproof the Ethernet cable.

What to do next

To troubleshoot or uninstall the access point, remove the RJ45 cable before you remove the access point from the installation location.