Pre-configuration for Selecting IP Mode

During a fresh installation, an appropriate IP mode (IPv4 single stack, IPv6 single stack, or Dual IP-stack) is selected as default in the IP configuration wizard. The IP mode selection is based on the IP addresses assigned to the interface. You can accept the default or change the deployment mode.

Ensure that the selected IP mode has an appropriate IP address configured on the VM Interface.

The following table describes the IP mode configuration on interface and the corresponding operational IP mode:

IP Mode Configuration on VM Interface Operational IP Mode
If IPv4 address is configured and no IPv6 address is configured on gateway interface IPv4 single-stack mode
If IPv4 address and IPv6 address with global scope are configured on gateway interface Dual ip-stack mode
If no IPv4 address is configured on gateway interface and only IPv6 address with global scope is configured IPv6 single-stack mode

During installation, system launches the following wizard to select a deployment mode. You can either accept or change the operational mode.

Note

Note