Configure Redundant Management

The Redundant Management Interface feature provides fault tolerance for the management path.

To configure Redundant Management, use the following commands.

Note

Redundant Management is supported on the SLX-9250 only.

1. Ensure interface management is enabled.
   

   device# configure
   device(config)# interface management 0
   device(config-Management-0)# ip address dhcp
   device(config-Management-0)# no shut
   device(config-Management-0)# exit

2. Enable redundant management on an interface/port.
   

   device(config)# interface ethernet 0/15
   device(conf-if-eth-0/15)# redundant-management enable
   device(conf-if-eth-0/15)# no shut
   device(conf-if-eth-0/15)# exit

3. Use show interface management and show interface ethernet to verify the configuration.
   

   (device)# show interface Management 0
   interface Management 0
   line-speed actual "1000baseT, Duplex: Full"
   oper-status up
   ip address "static 10.24.12.89/22"
   ip gateway-address 10.24.12.1
   ipv6 ipv6-address [  ]
   ipv6 ipv6-gateways [  ]
   redundant management port 0/15

   

   (device)# show interface ethernet 0/15
   Ethernet 0/15 is admin down, line protocol is down (admin down)
   Redundant management mode is enabled
   Hardware is Ethernet, address is 609c.9f5a.a35f
       Current address is 609c.9f5a.a35f
   Pluggable media not present
   Description: Insight port
   Interface index (ifindex) is 202350592 (0xc0fa000)
   MTU 9216  bytes
   Maximum Speed        : 10G
   LineSpeed Actual     : Nil
   LineSpeed Configured : Auto, Duplex: Full
   Priority Tag disable
   Forward LACP PDU: Disable
   Route Only: Disabled
   Tag-type: 0x8100
   Last clearing of show interface counters: 00:01:13
   Queueing strategy: fifo
   FEC Mode - Disabled
   Receive Statistics:    0 packets, 0 bytes
       Unicasts: 0, Multicasts: 0, Broadcasts: 0
       64-byte pkts: 0, Over 64-byte pkts: 0, Over 127-byte pkts: 0
       Over 255-byte pkts: 0, Over 511-byte pkts: 0, Over 1023-byte pkts: 0
       Over 1518-byte pkts(Jumbo): 0
       Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0
       Errors: 0, Discards: 0
   Transmit Statistics:
       0 packets, 0 bytes
       Unicasts: 0, Multicasts: 0, Broadcasts: 0
       Underruns: 0    Errors: 0, Discards: 0
   Rate info:
       Input 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate
       Output 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate
   Route-Only Packets Dropped: 0
   Time since last interface status change: 00:01:13