This installation guide for the Extreme Networks AP3020W covers hardware setup, physical specifications, mounting procedures, and regulatory compliance for a Wi-Fi 7 (802.11be) indoor wall plate access point managed using ExtremeCloud IQ. The AP3020W features a dual 2x2 radio design supporting either 2.4 GHz/5 GHz (Mode 1) or 5 GHz/6 GHz (Mode 2) operation, a dedicated sensor, two IoT radios, one multi-rate uplink port, and four GE Ethernet ports with PoE out. Power input is supported using 802.3af, 802.3at, 802.3bt PoE, or 12V DC. Installation procedures cover wall mounting using the included stainless-steel bracket, extended wall mounting using the ACC-BKT-AX-WP-EXT accessory, junction box mounting, and desk stand deployment. Pre-installation guidance addresses site survey considerations including RF interference, capacity planning, antenna radiation patterns, and DHCP, DNS, and NTP prerequisites. Network onboarding is supported through automatic DHCP-based discovery or manually using the ExtremeCloud IQ Mobile Onboarding App. LED behavior is documented for both ExtremeCloud IQ and ExtremeCloud IQ Controller firmware platforms. Regulatory and compliance information covers FCC, CE, Industry Canada, and regional notices for Brazil, China, Israel, Mexico, Thailand, Taiwan, the UK, and EU member states.
