delete ipsec

Syntax

• delete ipsec <1-255> admin-state enable

• delete ipsec <1-255> auth-key

• delete ipsec <1-255> cert-subject

• delete ipsec <1-255> egress-shaping-rate

• delete ipsec <1-255> encryption-key-length

• delete ipsec <1-255> esp

• delete ipsec <1-255> fe-tunnel-dest-ip

• delete ipsec <1-255> fragment-before-encrypt enable

• delete ipsec <1-255> ipsec-dest-ip

• delete ipsec <1-255> mtu

• delete ipsec <1-255> responder-only

• delete ipsec <1-255> tunnel-name

Command Parameters

admin-state enable

Disables the IPsec status on the specific IPsec tunnel.

auth-key

Deletes the authentication key that you configure on the specific IPsec tunnel.

cert-subject

Removes the certificate subject that you configure on the specific IPsec tunnel.

egress-shaping-rate

Deletes the egress shaping rate for the IPsec tunnel.

encryption-key-length

Resets the encryption key length for the specific IPsec tunnel to its default value, 128 bit.

esp

Removes the ESP cipher suite that you configure on the specific IPsec tunnel.

fe-tunnel-dest-ip

Deletes the destination IP address that you configure on the Fabric Extend (FE) tunnel.

fragment-before-encrypt enable

Disables the fragmentation of packets before IPsec encryption on the tunnel. By default, fragmentation before encryption is disabled.

ipsec-dest-ip

Deletes the destination IP address that you configure on the IPsec tunnel.

mtu

Resets the Maximum Transmission Unit (MTU) value for the specific IPsec tunnel to the MTU value configured globally.

responder-only

Deletes the mode that you configure for the IPsec session in FE tunnel.

tunnel-name

Deletes the name that you configure for the IPsec tunnel.

Default

None.

Command Mode

Fabric IPsec Gateway Configuration

Usage Guidelines

This command does not apply to all hardware platforms. For more information about feature support, see Fabric Engine Feature Support Matrix.

You must disable the IPsec administrative state on the tunnel before you can remove IPsec configuration.