qos if-rate-limiting

Syntax

• default qos if-rate-limiting [port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

• no qos if-rate-limiting [port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

• qos if-rate-limiting [port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}] rate <1000-40000000>

Command Parameters

port {slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

rate <1000-40000000>

Specifies the ingress rate limit in Kbps. The range is 1000–40000000.

Default

None

Command Mode

GigabitEthernet Interface Configuration

Usage Guidelines

This command applies to VSP 4900 Series only.