show spanning-tree rstp port config
Configure Ethernet Rapid Spanning Tree Protocol (RSTP) parameters to set RSTP parameters
for the port.
Syntax
-
show spanning-tree rstp
port config
-
show spanning-tree rstp
port config [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]
Command Parameters
- {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Shows RSTP port configuration.
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} identifies the slot and port
in one of the following formats: a single slot and port (slot/port), a range of
slots and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization and the
port is channelized, you must also specify the sub-port in the format
slot/port/sub-port.
