MAC Security with Pre-shared Keys Authentication Limitations

The following limitations apply to the MAC Security (MACsec) with Pre-shared Keys (PSK) Authentication:

• This initial release of MACsec only implements section point-to-point LANs within a secured network as described in Clause 7.4 MACsec to support Infrastructure LANs of the much broader standard outlined in IEEE802.1X-2010 Port-Based Access Control. All other sections and clauses are not supported.
  

  Note

  MACSec between customer edges over L2VPN is supported on untagged access ports.
• MACsec is only configurable using CLI commands. There is no SNMP access to the two MACsec MIBs defined by IEEE: IEEE8021X-PAE-MIB and IEEE8021-SECY-MIB.
• MACsec is not supported on ports with stacking enabled.
• MACsec is not supported on Extended Edge Switching ports.
• Hot swapping LRM/MACsec Adapters is not supported. MACsec must be disabled before hot swapping.
• The LRM/MACsec Adapters cannot be connected across slots on a stack.