ISW Series Managed Industrial Ethernet Switch Hardware Installation & User Guide
>
ISW Application Guides
>
Security Application Guide
>
Case 1: ACL for MAC Address
> Configuring One-directional MAC Address with CoS Marking Action (one VLAN, and don‘t care Ether Type) – Web UI
Published April 2022
Search this document
Print this page
Email this page
View PDF
Previous
Next
Preface
Text Conventions
Documentation and Training
Help and Support
Send Feedback
ISW-Series Switch Overview
8-port Switch Models
12-port Switch Models
28-port Switch Model
Power Supplies for Use with Your Switch
Site Preparation
Plan Your Site
Operating Environment Requirements
Meet Building and Electrical Codes
Set Up the Wiring Closet
Control the Temperature
Control the Humidity Level
Protect Your System from ESD (Electrostatic Discharge)
Rack Specifications and Recommendations
Mechanical Recommendations for the Rack
Ground the Rack
Provide Adequate Space for the Rack
Secure the Rack
Evaluate and Meet Cable Requirements
Label Cables and Keep Accurate Records
Install Cable
Handle Fiber Optic Cable
Cable Distances and Types
Use RJ45 Connector Jackets
Prevent Radio Frequency Interference (RFI)
Meet Power Requirements
Requirements for PoE Devices
Power Supply Requirements
Power Cord Requirements
UPS (Uninterruptible Power Supply) Requirements
Select a UPS
Calculate Volt-Amperage Requirements
Provide a Suitable UPS Transition Time
Follow Applicable Industry Standards
Install Your Switch
Safety Considerations for Installation
What You Will Need for the Installation
Mount the Switch
Connect Power Supplies, Alarm Relay, and Ground Connection
Turn on the Switch
Connect Network Interface Cables
Activate and Verify the Switch
Connect to the Management Console
Configure the Switch for Use
Monitor the Switch
System Status LEDs
Copper RJ45 Port LEDs
SFP and SFP+ Port LEDs
PoE LEDs
Reset, Upgrade or Downgrade Software
System Reset
Reset Configuration Defaults via CLI Command
Reset Configuration Defaults via Web UI
Upgrade and Downgrade Software
Important Deployment Considerations
ISW Series Technical Specifications
Power Options
Weights and Physical Measurements
Performance & Scale
CPU, Memory
Console Connector Pinouts
Standards
Environmental Specifications
Safety and Regulatory Information
Considerations Before Installing
General Safety Precautions
Maintenance Safety
Fiber Optic Ports and Optical Safety
GBIC, SFP (Mini-GBIC), QSFP+, XENPAK, and XFP Regulatory Compliance
Cable Routing for LAN Systems
Install Power Supply Units and Connect Power
Select Power Supply Cords
Battery Notice
Federal Communications Commission (FCC) Notice
Configuring One-directional MAC Address with CoS Marking Action (one VLAN, and don‘t care Ether Type) – Web UI
Navigate to
Configuration
>
Security
>
Network
>
ACL
>
Access Control List
.
Create a new
ACL
Profile (profile name:
CoSMarkingTest
).
Create a new ACL Entry rule under this ACL profile (Filter SrcMAC: 11 and
VLAN
ID: 4 frame to
CoS
: 2).
Bind this ACL profile to a GE port (PORT4).
Send frames between PORT3 and PORT4, and see test result.
