The following issues were resolved in ExtremeXOS 31.7-Patch1-36. Release 31.7-Patch1-36 includes all fixes up to and including the following versions: 11.6.5.3 and earlier, 12.0.5, 12.1.7, 12.2.2-patch1-12, 12.3.6, 12.4.5, 12.5.5, 12.6.3, 12.6.5, 12.7.1, 15.1.5, 15.2.4, 15.3.3, 15.4.1, 15.5.1, 15.5.2, 15.6.1, 15.6.2, 15.7.1, 16.1, 16.1.2, 16.1.3, 21.1, 22.1, 22.2, 22.3, 22.4, 22.5, 22.6, 30.1, 30.2, 30.3, 30.4, 30.5, 30.6, 30.7, 31.1, 31.2, 31.3, 31.4, 31.5, 31.6, and 31.7. For information about those fixes, see the release notes for the specific release.
Release 31.7 also includes fixes for issues found in Switch Engine 31.6. Release 31.6 was the first version of Switch Engine.
| Defect Number | Description |
|---|---|
| General | |
| EXOS-30094 | The footer should be printed without consideration of CLI paging. |
| EXOS-30566 | VLAN-based mirroring stops working if any port on the switch is partitioned. |
| EXOS-31711 | Remove the default IP from the tech-support collector. |
| EXOS-31786 | UDP profile doesn't forward traffic to /30 network if the switch interface has the same network configured. |
| EXOS-31802 | FAN OID returns only the first fan serial number. |
| EXOS-31811 | ExtremeXOS should throw an error to disable SLPP before configuring VPEX when it is enabled. |
| EXOS-31919 | Access VLAN traffic is not forwarded over MLAG ports toward the network VLAN. |
| EXOS-32016 | MAC locking behavior was not consistent with MLAG. |
| EXOS-32033 | Slot port wildcard does not work. |
| EXOS-32038 | The temperature is incorrectly displayed in the show temperature command output. |
| EXOS-32055 | RESTCONF: The switch doesn't respond to System API calls and the CPU stays high for hal and EXPY processes. |
| ExtremeSwitching X435 Series Switches | |
| EXOS-31906 | Switch stops transmitting power with a fault Overload to the AP port. |
| EXOS-31984 | ExtremeXOS rescue with a USB on X435 8-port models is not working with 32.1 and 31.7 releases. |
| ExtremeSwitching 5420 Series Switches | |
| EXOS-31477 | The "Image integrity check" field in the show switch management command output is set to "Unknown." |