Resolved Issues in ExtremeXOS and Switch Engine 31.7-Patch1-17
The following issues were resolved in ExtremeXOS 31.7-Patch1-17. Release 31.7-Patch1-17 includes all fixes up to and including the following versions: 220.127.116.11 and earlier, 12.0.5, 12.1.7, 12.2.2-patch1-12, 12.3.6, 12.4.5, 12.5.5, 12.6.3, 12.6.5, 12.7.1, 15.1.5, 15.2.4, 15.3.3, 15.4.1, 15.5.1, 15.5.2, 15.6.1, 15.6.2, 15.7.1, 16.1, 16.1.2, 16.1.3, 21.1, 22.1, 22.2, 22.3, 22.4, 22.5, 22.6, 30.1, 30.2, 30.3, 30.4, 30.5, 30.6, 30.7, 31.1, 31.2, 31.3, 31.4, 31.5, 31.6, and 31.7. For information about those fixes, see the release notes for the specific release.
Release 31.7 also includes fixes for issues found in Switch Engine 31.6. Release 31.6 was the first version of Switch Engine.
|EXOS-30174||SNMPv3 user configuration is lost after a switch reboot.|
|EXOS-30317||Occasionally, the first login failure is not recorded, which causes the user to get locked out only after “max-failed-login” + 1 failed login attempts.|
|EXOS-31172||Adjacency of a local interface IP address is shown as invalidated in debug hal show ipv4Adj output, which affects traffic flow.|
|EXOS-31532||Proxy ARP functionality using only the Switch MAC address instead of the VRRP MAC address despite the Proxy ARP being configured to use VRRP.|
|EXOS-31603||AAA process crashes with signal 6 while AAA process is re-transmitting the authentication request.|
|EXOS-31693||Include the show vlan command in show tech-support with default configuration.|
|EXOS-31702||HAL process crashes with signal 6 after continuous port flap.|
|EXOS-31748||With RADIUS authentication enabled on SummitStack, CLI install image inactive fails to copy the active partition image to the inactive partition of the backup node.|
|EXOS-31767||ExtremeXOS switch reports an error log "Update failed on unit 0 (No resources for operation), flags 0x40000100, flags2 0x0."|
|ExtremeSwitching X435 Series Switches|
|EXOS-31701||A memory leak occurs while accessing the switch via REST API.|
|EXOS-31709||The ExtremeSwitching X435 series inline-power randomly goes into the disabled state until the switch is factory reset.|