The topics in this section provide conceptual-based documentation for new ExtremeCloud SD-WAN-related features.
Feature |
Product |
Release introduced |
---|---|---|
Fabric Extend Integration with ExtremeCloud SD-WAN |
5320 Series |
Fabric Engine 8.10.1 Only 5320-48P-8XE and 5320-48T-8XE support more than one VRF with IP configuration. Beginning with Fabric Engine 9.0.3, you can specify the VRF that Auto-sense uses for SD-WAN on models that support a single active VRF. |
5420 Series |
Fabric Engine 8.10.1 |
|
5520 Series |
Fabric Engine 8.10.1 |
|
5720 Series |
Fabric Engine 8.10.1 |
|
7520 Series |
Fabric Engine 8.10.1 |
|
7720 Series |
Fabric Engine 8.10.1 |
|
VSP 4900 Series |
VOSS 8.10.1 |
|
VSP 7400 Series |
VOSS 8.10.1 |
|
Auto-sense port Multi-area SPB support |
5320 Series |
Not Supported |
5420 Series |
Not Supported |
|
5520 Series |
Fabric Engine 9.0.3 |
|
5720 Series |
Fabric Engine 9.0.3 |
|
7520 Series |
Fabric Engine 9.0.3 |
|
7720 Series |
Fabric Engine 9.0.3 |
|
VSP 4900 Series |
Not Supported |
|
VSP 7400 Series |
VOSS 9.0.3 |
The next section describes the Fabric Extend port state for Auto-sense.
When Auto-sense is enabled, LLDP uses the FE TLV to create Fabric Extend tunnels between two Fabric switches that connect over the Internet through the SD-WAN Appliance. This functionality is supported on a single port of the switch.
The FE states are as follows:
SD-WAN
SD-WAN-PENDING
After the first Auto-sense port receives an FE-TLV, the port transitions to the SD-WAN state. All other Auto-sense ports transition to SD-WAN-PENDING state and remain unconfigured. When the first port transitions to the SD-WAN state, the switch verifies that VLAN 4047, VRF, and IS-IS logical interface configurations do not exist, and dynamically configures the following connectivity parameters:
SD-WAN
as the
VLAN name associated with VLAN 4047 with origin ZTF
sd-wan
as the VRF name associated with the IP tunnel with
origin DYNAMIC
Note
On switch models that support a single active VRF, Auto-sense cannot create the dynamic SD-WAN VRF if an IP configuration already exists but you can manually specify the VRF name that Auto-sense uses for the SD-WAN configuration on these models.
SD-WAN-<ifidx>
as the tunnel name
SD-WAN Tunnel SrcIP
as the name associated with the Fabric Extend
underlay IP
IPv4 address for VLAN 4047
default route (0.0.0.0/0) with origin ZTF
Fabric Extend tunnels with origin ZTF for IS-IS logical interfaces
VLAN 4047 port membership
In the following cases, the port transitions to the SD-WAN-PENDING state: