ip address (loopback)

Configure a circuitless IP interface (CLIP) when you want to provide a virtual interface that is not associated with a physical port. You can use a CLIP interface to provide uninterrupted connectivity to your switch.

Syntax

Command Parameters

[vrf WORD<1-16>]
Specifies an associated VRF by name.
{A.B.C.D/X}
Specifies the IP address and subnet mask.
{A.B.C.D}
Specifies the IP address.
<1-256>
Specifies the interface identification number for the circuitless IP (CLIP).
multi-area-virtual-link

Specifies that the source IP address is used for a Mulit-area virtual NNI link.

<home | remote>
Specifies the transport area for the Multi-area virtual NNI link.
name WORD<0-64>

Specifies a name associated with the IP address.

Note

Note

If you do not assign a name when you configure virtual NNI links for Multi-Area boundary nodes for 7520 Series and 7720 Series, the system autogenerates the name and displays the name as Virtual-link.

Default

None

Command Mode

Loopback Interface Configuration