Configure the IS-IS Area for a Specific Tunnel

About this task

Note

You can only use this procedure on a switch with boundary-node abilities.

Perform this procedure to specify the IS-IS area where Auto-sense creates a specific ExtremeCloud SD-WAN-learned tunnel. This configuration overrides a global area configuration for all learned tunnels.

Procedure

In the navigation pane, expand Configuration > Fabric.
Select AutoSense.
Select the Sd-Wan Multi-Area tab.
Select Insert.
In Ip, type the destination IP address.
In Area, select home or remote.
Select Insert.

Sd-Wan Multi-Area Field Descriptions

Use the data in the following table to use the Sd-Wan Multi-Area tab.


Name	Description
Ip	Displays the destination IP address for an ExtremeCloud SD-WAN-learned tunnel.
Area	Specifies the IS-IS area where Auto-sense creates the tunnel. By default, Auto-sense creates SD-WAN logical interfaces in the home area.