Configure LLDP-MED Network Policies on Ports
About this task
Perform this procedure to configure LLDP-MED network policies on specific ports.
Procedure
- In the navigation pane, expand .
- Select Port MED.
- Select the Local Policy tab.
- Select Insert.
- In PortNum, select the ellipsis (...).
- In Port Editor: PortMembers dialog box, select the desired ports.
- Select OK.
- In PolicyAppType, select the application type.
- Optional: In PolicyVlanId, type the VLAN ID for the port.
- Optional: In PolicyPriority, type the priority level.
- Optional: In PolicyDscp, type DSCP value.
- Optional: Select Policy Tagged to enable VLAN tagging on the port.
- Select Insert.
Local Policy Field Descriptions
Use the data in the following table to use the Local Policy tab.
Name |
Description |
---|---|
PortNum |
Specifies the port. |
PolicyAppType |
Specifies the application type. |
PolicyVlanId |
Specifies the VLAN ID for the port, as defined in IEEE 802.1Q-2003. The value 0 is used if the device is using priority tagged frames, which means only the 802.1D priority level is significant, and the default VLAN ID of the ingress port is used instead. |
PolicyPriority |
Specifies the Layer 2 priority used for the specified application type, as defined in IEEE 802.1D-2004. The default is 0. |
PolicyDscp |
Specifies the value of the Differentiated Service Code Point (DSCP) associated with a specific port on the local LLDP-MED, as defined in IETF RFC 2474 and RFC 2475. The default is 0. |
PolicyTagged |
Specifies whether the application uses a tagged or untagged VLAN, as defined by IEEE 802.1Q-2003.
|