debug lacp
Enables or disables debugging for the Link Aggregation Control Protocol (LACP).
Syntax
debug lacp
{
all
|
cli
|
event
|
ha
|
pdu
[
rx
{
all
|
interface
ethernet
slot/port
|
tx
{
all
|
sync
|
timer
|
trace
level
number
}
Command Default
LACP debugging is disabled.
Parameters
-
all
- Turns on all debugging.
-
cli
- Turns on command line interface debugging.
-
event
- Turns on event debugging.
-
ha
- (Not currently supported) Echo HA events to
the console.
-
pdu
- Echo PDU content to the console.
- rx
all
- Turns on debugging for received LACP packets on all interfaces.
- rx
interface
- Turns on debugging for received LACP packets on the specified interface.
-
interface
- Specifies the interface to be monitored.
-
ethernet
- Represents a valid, physical Ethernet interface.
- slot
- Specifies a valid slot number. The only valid value is 0.
- port
- Specifies a valid port number.
- tx
all
- Turns on debugging for transmitted LACP packets on all interfaces.
- tx
interface
- Turns on debugging for transmitted LACP packets on the specified interface.
-
sync
- Echo synchronization to consoles.
-
timer
- Echo timer expiration to console.
-
trace
level
number
- Specifies the trace level number. Valid values range from 1 through 7.
Modes
Privileged EXEC mode
Usage Guidelines
Enter
terminal monitor to display debugging outputs on a particular cmsh session.
Enter
no debug lacp to disable LACP debugging.
Examples
To enable debugging of LACP PDUs for transmitted and received packets on all interfaces:
device# debug lacp pdu tx all
device # debug lacp pdu rx all
device# show debug lacp
LACP rx debugging is on
LACP tx debugging is on
