Configuring Administrative Groups

Use the interface level exclude-any | include-all | include-any command to configure administrative groups for dynamic bypass LSPs to be created corresponding to a protected link.

Use the group-number or group-name parameter for the following:

Include-all group-number or group-name: include the entire administrative group-number or group-name.
include-any group-number or group-name: include the entire administrative group-number or group-name.
exclude-any group-number or group-name: include the entire administrative group-number or group-name.

To configure administrative groups, complete the following steps.

Enable the device for configuration.
```
device>configure
```
Enable the MPLS router.
```
device(config)# router mpls
```
Enable MPLS-capable interfaces and specify the selected Ethernet interface. In this example, the selected Ethernet interface is 0/8 .
```
device(config-router-mpls)# mpls-interface ethernet 0/8
```

Enable the interface level dynamic bypass.

device(config-router-mpls-if-ethernet-0/8)# dynamic-bypass

Configure the administrative groups with any of the following choices. All three commands can be used simultaneously.
- Include-all command. In this example, the administrative groups 4 and 5 are included in the configuration.
```
device(config-router-mpls-if-ethernet-0/8-dynamic-bypass)# include-all 4 5
```
- Include-any command. In this example, the administrative groups 6 and 7 are included in the configuration.
```
device(config-router-mpls-if-ethernet-0/8-dynamic-bypass)# include-any 6 7
```
- exclude-any command. In this example, the administrative groups 10 and 11 are included in the configuration.
```
device(config-router-mpls-if-ethernet-0/8-dynamic-bypass)# exclude-any 10 11
```

The following example combines the steps above the configure administrative groups.

device>configure
device(config)# router mpls
device(config-router-mpls)# mpls-interface ethernet 0/8
device(config-router-mpls-if-ethernet-0/8)# dynamic-bypass 
device(config-router-mpls-if-ethernet-0/8-dynamic-bypass)# include-all 4 5
device(config-router-mpls-if-ethernet-0/8-dynamic-bypass)# include-any 6 7
device(config-router-mpls-if-ethernet-0/8-dynamic-bypass)# exclude-any 10 11